Wiring mirco relay

[graumann]

I was wonder if anyone can give me any pointers on how I would be supposed to wire in this relay to use it as a switch. The situation is I wish to use the relay AQY272 to switch on a 1.5V permanent power supply triggered by a 1.61V 110mA hydropowered dyno. From what I believe I understood I could have had the permanent supply on pins 3 & 4 triggered by the current going from pin 1 to 2. Have I made a mistake? I only have the vaguest idea how these photoMOS relays work

 

http://pewa.panasoni...age-catalog.pdf

Edited April 29, 2012 by graumann

[Nessalco]

Pins 1 & 2 are your trigger, as you thought. Must be properly polarized.

 

Kevin

 

I was wonder if anyone can give me any pointers on how I would be supposed to wire in this relay to use it as a switch. The situation is I wish to use the relay AQY272 to switch on a 1.5V permanent power supply triggered by a 1.61V 110mA hydropowered dyno. From what I believe I understood I could have had the permanent supply on pins 3 & 4 triggered by the current going from pin 1 to 2. Have I made a mistake? I only have the vaguest idea how these photoMOS relays work

 

http://pewa.panasoni...age-catalog.pdf

[graumann]

Cheers for that Kevin, maybe there is something else I have forgotten about, the trigger current should be sufficient if I read the specs right.